English
German
Russian
TurkishUV RESISTANT LIQUID MEMBRANE
UV RESISTANT LIQUID MEMBRANE
DESCRIPTION
Forcechem® Forceaqua UV Membrane is a polymer- based waterproof product. When applied, it forms a jointless and waterproof layer. It does not contain solvent and can easily be applied on dry or moist clean surfaces. By means of special polymers inside, it is not affected by UV and sun rays. It prevents overheating by reflecting the sunlight at 80%. High adhesion strength, nonflammable and not compatible with bitumen. It is dirt-proof and keeps its first state and appearance for years. In insulation of these kinds of floors, using liquid rubber membrane is recommended. Forcechem® Forceaqua UV Membrane is white but it can be coloured in any desired colour. It is 250% elastic.
APPLICATION AREAS
USAGE
The insulation surface must be clean, dry or slightly moist. If there are materials such as dirt,mud, rust or oil on the surface, they must immediately be cleaned. It is not used in places where salt efflorescence or water course from negative side is available. If there are cracks and repairs on the application surface and will be beveled, it must be done before with waterproof elastic repair mortar. Especially on large spans and thermal insulated floors, 75 gr of liquid net is recommended to apply. If there is dilatation on application surfaces, it must be insulated with waterproof elastic mortar. Then, the insulation must be started. Forcechem® Forceaqua UV Membrane is ready to use. It is necessary to mix homogeneously after its tap is opened.
Primer Application
All application surfaces must be lined with Forcechem® Forceaqua UV Membrane, diluted with water at a ratio of 1:1. The primer application must be done with a stiff brush. After the application, leave it to dry for 4 hours.
Insulation Application
Forcechem® Forceaqua UV Membrane is applied on the prepared surface without dilution in 2 layers with an interval of 4 hours. Applied insulation application must be protected against rain and water for four hours. The application must not be done below +50C or in wet and frozen soils. Especially in flat roofs, adequacy of sloping the roof must be checked.
Having water outlets and preventing the water to form a pond on the roof must be regarded.
CONSUMPTION
1kg/m² (primer +in 2 coats)
TECHNICAL SPECIFICATIONS
| Appearance | White color liquid |
| Application Temperature | Between +50C and +350C |
| Toxicity | Non-toxic |
| Storage and Shelf Life | In its unopened original package, stock up maximum 3 buckets on each other in a cool and dry place. Shelf life is 12 months from date of production under proper storage conditions. Protect against sunlight and frost. |
The values above are valid at +210C and 50% relative humidity.
