THERMAL INSULATION BOARD PLASTER

urun-denizkim-dekoratif-kaplama

DESCRIPTION
Cement based polymer reinforced plaster used for heat isolation, plasterine of polystyrene hard foam and sheets.

APPLICATION
1 bag of (25 Kg) Denizkim® Thermal Insulation Board Plaster is mixed with 6,5-7 lt. water in a clean container until it gets mastic thickness. After reting the preparation for 5 minutes, it is mixed again. Preparation is applied on to surface by trowel at 2-2,5 mm thickness. After that plaster netting is applied. Plaster is left for drying. After is dried, last coat is applied at 1-1,5 mm according to the climatic conditions.

APPLICATION AREAS

Indoor and outdoor applications
Thermal Insulation Board Plaster applications
For repairing thin plaster applications
For plastering the surfaces where flexibility is required.

APPLICATION LIMITS

It can not be applied to metalic surfaces

PREPERATION OF SURFACE AND APPLICATION SPECIALITIES

All the surface should be covered with plaster mesh,
There should not be gaps between insulation boards,
The surface should be moisted before application.
The plaster has mortar proofing properties,

TECHNICAL SPECIFICATIONS

Color	Grey
Determination of Air Content of Fresh Mortar	≥ 1150 kg/m³
Determination of Air Content Of Hardened Mortar	1250±200 kg/m³
Partical Size	< 0,8 mm.
Flexural Strength	≥ 2,0 N/mm²
Compressive Strength	≥ 6,0 N/mm²
Thermal Insulation Board of Adhesion	≥ 0,08 N/mm²
Water Absorption	≤ 0,5 kg/m².dk^0,5
Water Vapour Permeability	µ ≤ 15
Application time	40-60 minutes
Ready Mix Applicable	6 hour
Fire Response Class	A1
Opening to the Traffic	24 hour
Application Temperatures	+5⁰C / 35⁰C
Strenght of Freeze	-40⁰C / 100⁰ C
Toxity	Non Toxic
Consumption	5 kg/m²
Package	25 kg craft packet
Mixing Ratio	25 kg powder / 6,5-7 lt. water
Storage Life	12 months in suitable storage conditions It must be closed carefully when it will not be use and it has to be used 1 weeks it is opened

The values above are valid at +21 ⁰C and %50 relative humidity