PRIMER LIQUID

PRIMER LIQUID

DESCRIPTION
It is an acrylic-based plaster for absorptive surfaces.

APPLICATION AREAS

• Inside and outside places, horizontal and vertical claddings
• To protect against to moisture of gypsum, gypsum panel, aerated concrete and lime stuff
• To minimize chalking of surface, workability time of mortar and mortar bubbles before cement finish
• As an under paint thermal sheathing plaster in exterior applications (It becomes transparent after drying)
• As a plaster in wallpaper applications

POINTS TO CONSIDER

• Application under sunlight and strong winds should be avoided. Application must be done when the surface temperature is between +5°C and +25°C.
• It cannot be applied on wood, OSB, PVC, bitumen surfaces, painted and metal surfaces.
• The material must be protected from freeze.
• If there is a risk of freeze in the following 24 hours, it should not be applied.
• After application, prevent the surface from soiling. Otherwise the following application will not bond with the primer properly and adhesion will not take place.
• After drying, the primer becomes transparent. If pressed upon with a finger, it will give a feeling of stickiness.
• Wearing protective gloves during use is recommended. For further information, please look at the material safety data sheet.

ADVANTAGES

• It is one component, and easy to prepare and apply.
• It does not contain solvents.
• It prevents the water loss of cement mortars in absorbing surfaces. It prevents the formation of capillary cracks.
• It is resistant against humidity.
• It can be used on internal and external places.
• It can also be used as primer in sheating applications.

SURFACE PREPARATION
The surface must be cleared from paint, rust, oil, paraffin that will prevent clean and proper application. It is important that is of the same scales with the surface.

USAGE
It is diluted according to application method and applicated on a surface with roller. Do not allow to ponding on the surface during the application.

To protect against to moisture the gypsum, aerated concrete and lime stuff surfaces; Forcechem®  Primer Liquid is applicated to surface without dilution. The second layer is diluted with the rate of 1/2 and applicated after the first layer dried. It should be waited to dry of plaster. It is controlled by pushing finger and if it is dried the other applications can proceed. (Consumption: 175-200 gr/m²)

To protect dehydration of mortar and chalking of surface before cement finishes;   Forcechem®  Primer Liquid is applicated to surface without dilution. It must be waited for 24 to drying of plaster. It is controlled by pushing finger and if it is dried the other applications can proceed. (Consumption: 160-200 gr/ m²)

For thermal sheathing plastering; Forcechem®  Primer Liquid is applicated to thermal sheathing surface without dilution. It must be waited for 24 to drying of plaster. It is controlled by pushing finger and if it is dried and thermal sheathing can proceed. (Consumption: 140-160 gr/ m²)

As a plaster for wallpaper and painting; Forcechem®  Primer Liquid is diluted with the rate of   1 /1 and applicated with roller. It must be waited for a while to drying of plaster. If it is dried the other application can proceed. (Consumption: 90-100 gr/ m² diluted)

To fix the ceramics on gypsum, gypsum panel and lime stuff surfaces

Forcechem®  Forceprimer AAA is the best application in this kind of surfaces. (See Forcechem®  Forceprimer AAA)

Before plastering of brut concrete surface;

Forcechem®  Forceprimer BBA is the best application in this kind of surfaces. (See Forcechem®  Forceprimer BBA)

CONSUMPTION
100-200 gr/m²

TECHNICAL SPECIFICATIONS

The values above are valid at +21 ⁰C and %50 relative humidity.